What are the common faults encountered in mineral water production lines

一、 There is a dripping phenomenon after the closure of the mineral water production line

If this phenomenon occurs in the mineral water production line, it may be due to damage to the filling nozzle hole. In this case, the filling nozzle can be removed and repaired before installation. It is important to note that the diameter of the hole hole should not exceed 7.5mm. After repairing the aperture, gently grind the flat surface of the aperture on the water sandpaper. If there is no problem with the can material mouth, it may be that the ball valve inside the filling head is damaged, and a new ball valve needs to be replaced.

二、Inaccurate filling volume

This type of malfunction is quite common in the application process of mineral water production lines, especially when filling large-sized materials. Insufficient replenishment in the material tank of the mineral water production line can cause unstable liquid level. In this case, we can re adjust the ball valve above the filling head or increase the replenishment amount, or reset and extend the filling time to slow down the filling speed to solve this problem.

三、Stable liquid level, but inaccurate filling volume

This type of malfunction also frequently occurs in mineral water production lines, mostly caused by debris blocking the filling channel, mainly in the filling mouth or at the inlet of the material trough. It only needs to be checked and cleaned to solve the problem.